Minuteman C46300-02 ET Extraction Tool - Manual (Page 7)

Parts and Instruction Manual
Page 3
USER MAINTENANCE INSTRUCTIONS
All service and repair should be performed by qualified vacuum service representative or electrician.
No user serviceable components are employed in the electrical assembly. No lubrication of the
motor is required.
DAILY MAINTENANCE
1. The powerhead should be cleaned daily. Flush pumping system with 1 gallon of
clean water after use.
2. Check and clean vacuum inlet and solution inlet daily.
3. Brushes should be cleaned after each use.
4. Spray jet should be checked for correct spray pattern and cleaned if plugged. Do not
clean out spray tip with pins or wire, this may cause damage to the jet spray pattern
and cause streaking.
5. Protect equipment from freezing. Severe pumping system damage can occur if
allowed to freeze.
6. Inspect vacuum hoses for tight connections. Check electrical cable for abrasion
or cuts in jacket. Cord should be replaced if worn or damaged.
MONTHLY/BI-MONTHLY MAINTENANCE
The Solution Pump System should be purged monthly to remove alkaline residue build-up. To
flush system out, use 1 quart of white vinegar to 1 1/2 gallons of clean hot water, followed by a
clear 1 1/2 gallon rinse. Clean spray jets if required.
CORD STORAGE
While not in use storage can be accomplished by winding cord around machine. Cord hooks
are provided.
• Do not use with damaged cord or plug. If appliance is not working as it should, has
been dropped, damaged, left outdoors, or dropped into water, return to service center.
• Do not pull or carry by cord, use cord as handle, close a door on cord, or pull cord
around sharp edges or corners. Do not run appliance over cord. Keep cord away
from heated surfaces.
• Do not unplug by pulling cord. To unplug, grasp the plug, not the cord.
• Do not handle plug or appliance with wet hands.
This equipment should be stored indoors and not exposed to rain.