Minuteman C46300-02 ET Extraction Tool - Manual (Page 9)

Parts and Instruction Manual
Page 5
EXTENSION WAND INSTALLATION
1. Detach power cord from the trigger guard and
the cable clip.
2. Disengage powerhead from handle
assembly by depressing the burgundy
locking button and disconnecting
coupling 1. (see fig. 3).
3. Insert the stainless steel extension wand
curved end, (see fig. 4) into the powerhead
assembly until the locking button is
engaged. Connect coupling 2 to the
hose assembly on the powerhead.
4. At the other end of the extension wand,
(fig. 4) insert the handle assembly to the
flared end until the locking button is
engaged. Connect coupling 1 from
handle assembly to the hose assembly
on the extension wand.
5. Reposition the power cord to the trigger
guard and secure it to the cable clip.
FIG. 4
BRUSH REPLACEMENT
Before reinstalling the brush, make sure that
the drive lugs on the pulley are oriented as
shown. Align notches on brush to engage with
lugs on pulley. Position brush to reinstall brush
shaft.
FIG. 3