Minuteman Phenom L1518 Dual Motor Upright Vacuum - Manual (Page 8)

8
Safety Information
1.4 Maintenance information
Proper maintenance of the brush vacu-
um cleaner is a major aspect in prevent-
ing accidents.
• The maintenance work and mainte-
nance intervals prescribed in the op-
erating manual must be adhered to.
• Operating personnel must complete
the necessary daily and weekly
maintenance work. All other mainte-
nance work must be completed at
your nearest Minuteman service
center.
• Before completing any cleaning and
maintenance work or replacing
parts, switch the machine off and
disconnect the power plug from the
power socket. This applies particu-
larly with regard to work on the elec-
trical system!
• Suitable tools must be used for
cleaning and maintenance work.
• Spare parts must comply with the
minimum technical requirements
stipulated by the manufacturer! This
is ensured by the use of original
spare parts.
• It is not permitted to clean the ma-
chine with a pressure washer or
steam blaster.
• It is not permitted to use aggressive
and corrosive cleaning agents.
• Where necessary, the Minuteman
Phenom must be subjected to an an-
nual electrical safety test by an au-
thorized expert in accordance with
the accident prevention regulations.
The results of the test must be docu-
mented in writing and kept at least
until the next test.
• Observe legal regulations and local
directives.
1.5 Particular risks
• The following applies for fault
location and fault clearance: Switch
the machine off immediately and
disconnect the power plug from the
power socket!
• Clear faults immediately.
• Always disconnect the power plug
when working on the electrical
system.
• Work on the electrical equipment
may only be carried out by
electricians who have received the
necessary training and in
accordance with the electrical
engineering regulations.
• The machine's electrical equipment
must be inspected/checked at
regular intervals. Defects, such as
loose connections and cable
damage, must be rectified
immediately.
• The appliance is to be disconnected
from its power source during
cleaning or maintenance.
• Only use original fuses with the
prescribed amperage.
• Regularly examine the supply cord
for damage. If damaged, replace the
cord, specified, before further use.
• The damaged power cable must be
replaced at an authorized
Minuteman service center or by an
appropriately qualified electrician.