Minuteman PORT A SCRUB 14 - Manual (Page 12)

Mount Squeegee (Initial Fitting)
˜
˜
˜
Lift squeegee and hold it to the squeegee holders (3).
Mount squeegee (1) to the squeegee holder by means of screws (2) as
represented
Check the smooth running of the bottom sleeve at the squeegee
holders for perfect hinging.
Dismount Squeegee
˜
˜
˜
Lift brush head of the Port A Scrub 14 in order to access the squeegee screws.
Remove both screws (2) as represented.
Pull squeegee to the bottom to remove it from the machine.
Change Sealing Strips
No tools are required for dismounting the sealing strips. Proceed as
follows:
Dismount squeegee (refer to paragraph “Dismount squeegee” ).
Unscrew knurled screw (1)
Remove support strip
Proceed to mounting of new sealing strip in reverse order.
Tighten the knurled screws (by hand) and from the centre towards the
outsides (slotted sealing strips point to the front, plain ones to the back)
˜
˜
˜
˜
˜
Proceed as follows for cleaning the nozzle:
(I) Remove nozzle
˜
˜
˜
Dismount brushes from the Port A Scrub 14 (see
“Dismount/Mount Brushes”).
Lift machine and lay down on its back as represented.
Turn the nozzle to the left
(II) Clean nozzle
·
˜ Clean nozzle by compressed air or water
(III) Mount nozzle
·
˜
˜
˜
After cleaning, insert nozzle by screwing clockwise
.
make sure that the nozzle slot is as the mounting direction of the brushes.
Upright machine
1.squeegee
2.squeegee screw
3.squeegee holder
1. Knurled screw
2. Support strip
3. Sealing strip
1
2
3
The rear sealing strip can be turned round if worn at the front edge.
NOZZLE
Tighten
Loosen
Clean nozzle
The nozzle clogs after some hours of operation. It thus
required to clean the nozzle at daily intervals before start of
operation.
Nozzle Slot
Squeegee
The Port A scrub 14 has been equipped with a squeegee of 450 mm working width. The squeegees can be lifted-
out alternately
Check the squeegee for collected foreign particles and
12
1
2
3