Minuteman PORT A SCRUB 14 - Manual (Page 15)

The electric system of the Port A Scrub 14 operates at a mains voltage of 110-120V /
60Hz.
After opening the machine top, the brush motor and the suction turbine are well
accessible.
A T10A fuse (E) protects the suction turbine and has to be replaced by the same type
if blown (T stands for slow-blow).
The suction turbine is low-maintenance type; its carbon brushes only have to be
checked after every 200 hours of operation.
The brush motor is protected by a cutout (G) which can be manually reset. In case of
tripped cut-out, detect the cause and remedy before re-starting the machine.
The pump is protected by a T0.5A fuse (F). Replace by the same type of fuse.
Reset the cut-out by pushing down the transparent dome of the fuse box. After
tripping, wait for approx. 30 seconds before resetting.
In case of repeated fuse blowing detect the cause. We recommend having all work at the electric
System done by qualified personnel only.
E
G
F
E .Suction motor fuse
F. Pump fuse
G. Brush motor cut-out
Electric System
Before starting work at the electric system, disconnect the mains plug. After work at the electric
system is finished, proceed to a safety test
Dimensions
Length
mm 700
Width mm 470
Height (with closed Handle) mm 540
Working width
Squeegee
mm 450
Scrubbing mm 350
Surface performance,
Theoretical
m2/h 1400
Driving speed Up to km/h 4
Technical Data
15
Weights
Deadweight, dry kg 40-43
Total weight, ready to operate, wet kg 50-53