MIDLAND CT510 - Manual (Page 44)

44 | Instruction Guide Midland CT510
Shortcut operations
To speed up the activation of some functions, you can press F/ along
with another one. Here below the list.
1. Squelch threshold adjustment.
Press F/ and 1/SQL to enter the squelch threshold setting. Select
the desired level (from 0 to 9) by rotating the POWER/DIAL knob.
2. High/low power adjustment
Press F/ and 2/PWR to enter the high/low power setting; you can
select it by rotating the POWER/DIAL knob. If the low power is
selected, “L” will appear at the bottom of the LCD.
3. Priority scan setting
To set the priority scan press F/ and 3/PRI; this function is availa-
ble in MR or CH mode.
4. Shift offset direction setting (Repeater shift)
Press F/ and 4S-D to enter the shift offset direction in VFO mode.
Rotate the POWER/DIAL knob to select downwards ‘-‘ or upwards
‘+’. When the repeater shift is enabled, the LCD will show the relati-
ve icon (‘+’ or ‘-‘ depending on what you chose).
5. Channel spacing setting
Press F/ and 6 STEP to enter the channel spacing setting. Rotate
the POWER/DIAL knob to select the desired setting; you can choo-
se amongst: 5/6.25/10/12.5/25.0/37,5/50.0/100.0 KHz.
6. Enabling / disabling the VOX function
Press F/ and 7 VOX to activate/deactivate the VOX function. Select
ON or OFF by rotating the POWER/DIAL knob.
7. FMW Radio mode
Press F/ and 8 FM to enter the FMW radio mode; at the bottom of
the LCD, the FM icon will appear. To select the desired frequency ro-
tate the POWER/DIAL knob or edit it directly with the keypad. The
frequency range is 88.00 - 108.00 MHz. To exit push again F/ and
8 FM. In FMW radio mode, CT 510 can monitor the receiver signals
in the amateur band. When you receive a call, the radio switches
temporarily in FM mode. After 5 seconds from the end of the call,
the radio returns to FMW mode.