MIDLAND CT510 - Manual (Page 45)

Instruction Guide Midland CT510 | 45
8. Keypad beep setting
Press F/ and 9 BEEP to enter the keypad beep setting. rotate the
POWER/DIAL knob to select amongst OFF / TONE /VOICE.
9. CTCSS / DCS setting
Press F/ and 0 SQT to set CTCSS sub-audio tones and DCS digital
codes. If you push again F/ you set the tones in reception and/or
transmission. To switch between CTCSS and DCS press repeatedly
the VFO key.
OFF → CTCSS → DCS N → DCS I → OFF.To select a CTCSS tone or a
DCS code rotate the POWER/DIAL knob; press ENT to confirm and
U/V to exit.
10. Scan
Press F/ and VFO to start scanning. To change the scanning direc-
tion rotate the POWER/DIAL knob.
The scan can be done in VFO, MR and CH modes.
11. Channel storage
Press F/ and U/V; rotate the POWER/DIAL knob to store the
desired channel. Press ENT to confirm.
12. Menu mode
Press F/ ENT to enter the menu mode. See chapter “Menu opera-
tions”.
Number key operation
In VFO mode, you can select a frequency directly by editing the number
on the keypad. If this number is out of band, the display will show “ER-
ROR”. In MR mode this number selects a stored channel.