MIDLAND G12 - Manual (Page 18)

8
English
2) Keep the button + pressed and turn your device back on. All
symbols on the display light up for about one second and you
hear a beep sound of confirmation.
3) When the display comes back to its normal status, release the +.
The roger beep will be disabled.
2 At point number 2, when roger beep is disabled it is given as a
two-tone signal, while its activation is signalled by a beep sound
followed by a two-tone signal.
6 Functions of the MENU button
With the MENU button you can set the basic functions of your
transceiver according to your preferences: selection of channel, VOX
mode, vibrating alert, scanning of channels, etc. In order to recall and
set the required function do as follows:
1) Press/scroll the MENU button to select the desired function to set,
(e.g.. Po (transmission power), as it has already been described
in par. 5.9).
2) Press the + or – button to set the currently selected function.
According to the case you can scroll different values on the
display (e.g. for transmission power you can choose between the
values Lo or Hi), or you can select On (function enabled) or Off
(function disabled).
3) In order to memorize the chosen setting press the PTT button or
wait for a few seconds. The device will go back to standby mode
having memorized the chosen settings.
2 After you have carried out step number 1), it is necessary to carry
out each successive operation within few seconds, or the device
will go back to standby mode confirming current settings.
2 If, after you have carried out step 2) you wish to set another
function, go back to step 1 immediately.
The following table lists the functions which can be set according to
the number of times the MENU button is pressed.