MotorVac TRANSTECH III - Manual (Page 10)

[email protected] www.motorvac.com
TransTech III Auto-Prime Procedure
(For first time set-up only)
Set-Up Instructions:
1. Check the output/return hoses, battery connections, and all external components for damage.
2. Fill the CLEAN FLUID tank with approximately 6 quarts (5.7 liters) of new ATF.
3. Connect two compatible adapters to each other, secure tightly. Attach the CLEAN FLUID & INLINE
RETURN hoses together using the connected adapters. Ensure that both hoses have no kinks or visual
damage.
4. Place the waste hose into the clean tank fill neck with the ball valve open.
5. Attach the units’ red (+) battery clip to vehicle’s positive battery terminal; connect the black (-) battery clip
to a solid ground point as far from the battery as possible.
6. Press and hold the CHANGE FLUID button for 5 seconds until the unit sounds the alarm. The FILL and
DRAIN LEDs will flash. Press and hold the CHANGE FLUID button again for 5 seconds until the unit
sounds the alarm. The DRAIN, FILL and COMPLETE LEDs will cycle in a clockwise direction while the
unit is performing the Auto-Prime procedure. The unit will pump fluid from the clean tank to the waste
tank. The unit will then set the waste tank zero level by pumping fluid from the waste tank into the clean
tank
7. Return the hoses to their original location.
8. The initial setup is complete.
8