MP Pumps HTO 300 INSTALL - Manual

FORM 3065-B
MP PUMPS HTO SERIES
HTO 300 INSTALLATION AND SERVICE INSTRUCTIONS
This bulletin must be read completely before installing, operating, or servicing the pump.
WARNING:
If any of the items listed below are violated, serious injury or death from burns caused
by hot oil may occur.
• DO NOT perform service or maintenance when
the pumping system is pressurized or hot -
serious injury or death from burns caused by
hot oil may occur.
• DO NOT operate the pump in a manner that it
was not intended to be used.
• DO NOT install for use in an open environment
where people are present.
• DO NOT install in a rigid piping system that
does not allow the pipe to expand and cause
the pump to be strained.
• DO NOT continue to operate the pumping
system when a known leak exists or the
system continues to smoke.
• DO NOT continue to operate the pump when
unusual noise or vibration occurs.
• DO NOT install or use near water where the
pumping system may come into contact with
water or is splashed by water.
• DO NOT operate beyond the pressure or
temperature limits stated in the product
literature, see form 9001.
• DO NOT allow severe temperature changes
to occur in a short time period within the
pumping system.
• DO NOT mix different types or grades of oil
within the oil system.
• DO NOT use an oil that is not a recommended
heat transfer oil by the manufacturer.
• DO NOT exceed the maximum oil temperature
rated by the oil manufacturer at the hottest
point in the pumping system.
• DO NOT mount the pump such that high
piping loads exist on the pump flanges.
®