Diamond Products CC1300XL - Manual (Page 22)

18
Figure 18: CC1300XL Handwheel
Raising the Saw
1. Pull out the index plunger and turn it 90° to
remove from the plunger groove. Turn the
handwheel clockwise (CC1200) or
counterclockwise (CC1300XL) to raise the saw.
2. Turn the index plunger 90° to lock it back into
the plunger groove. Turn the handwheel slightly
to lock the handwheel.
Lowering the Saw
1. Pull out the index plunger and turn it 90° to
remove from the plunger groove. Turn the
handwheel counterclockwise (CC1200) or
clockwise (CC1300XL) to lower the saw.
2. Turn the index plunger 90° to lock it back into
the plunger groove. Turn the handwheel slightly
to lock the handwheel.
Fuel System (Gas Models)
WARNING
• DO NOT operate the saw with a fuel leak.
• DO NOT fuel the saw with the engine
running.
• DO NOT smoke or expose
fuel to open flames when
filling the fuel tank or working
with fuel.
CAUTION
• Clean up spilled fuel prior to starting the
engine.
• Fuel may seep out from the fuel cap vent
(applicable models) when the saw is
raised.
Fueling the Saw
Fill the fuel tank as necessary.
1. Lower the saw so the engine is level.
2. Stop the engine and let the saw cool down.
3. Remove the fuel tank cap.
Figure 19: Fuel Tank and Cap
4. Fill the fuel tank with unleaded gasoline. Refer
to the engine manual for refueling information.
5. Replace the fuel tank cap and tighten to secure.
Storage
Refer to the engine manual for fuel
recommendations when storing the saw.