Diamond Products CC1300XL - Manual (Page 34)

30
Daily Maintenance Task Chart
Table 7: Daily Maintenance Task Chart
Date
      
1.
Lubricate blade shaft bearing
grease fittings daily, or two
to three times daily when dry
cutting.
2.
Inspect belts after first four
hours of use, and then daily
for tension and wear.
Replace or re-tension as
necessary.
3. Inspect saw for damages.
4. Tighten loose nuts and bolts.
5.
Clean air filter daily or two to
three times daily when dry
cutting (see engine manual).
6.
Check fuel level and fill as
necessary.
7.
Check engine oil level and fill
as necessary (see engine
manual).
8. Wipe down saw’s exterior.
9.
Wipe down engine/motor
exterior and guards.
10. Look for fluid leaks.
Refer to the engine manual for daily engine maintenance tasks.