Diamond Products CC1300XL - Manual (Page 36)

32
Troubleshooting
Table 10: Saw Troubleshooting
Symptom Problem Solution
1. Saw will not raise. Index plunger in?
Pull index plunger out to move
handwheel.
2. Saw will not lower. Index plunger in?
Pull index plunger out to move
handwheel.
3. Blade does not cut straight.
Excessive force applied while
sawing?
Reduce forward speed.
Wrong blade for application?
Contact dealer/manufacturer of
blade.
4. Short belt life.
Loose belts causing slippage? Check belt tension regularly.
Sheaves misaligned?
Use straightedge to check blade
shaft sheave alignment.
Worn sheave grooves?
Check for groove wear and replace
as necessary.
Overheating of belts? Check belt tension.
Refer to the engine/motor manual and manufacturer for engine troubleshooting information.