Diamond Products CB700 Drill Motor - Manual (Page 15)

E. Gently pull the gear housing apart. Only a small separation is needed to fit
two flat screw drivers into the housing’s gap. The screw drivers should be
inserted in opposing directions. Gently apply an even amount of force on both
tools to complete the housing separation.
F. Using the supplied open box wrench, hold the spindle in place.
G. Insert the torque wrench with a compatible clutch tool onto the gear
housing clutch nut as shown below. Rotate the wrench clockwise until the gauge
reads 20N-m
I. With the clutch nut properly tightened, reassemble the housing. To
reassemble press the two halves of the housing together. Make sure the
orientation and internal components mate correctly. Now sit the drill on the
motor’s back side so the spindle faces upwards. Using a mallet lightly tap the
housing closed. Every so often turn the spindle to guarantee the gears are
meshing together instead of interfering. Force must be distributed evenly
around the housing to keep the two halves level as they come together.
J. Reattach the four screws to complete the gear housing assembly.
.
14