Diamond Products CB700 Drill Motor - Manual (Page 4)

21. Make sure power is in “OFF” position before plugging in power cord to
prevent any accidental activation.
22. If cord/plug is damaged do not operate.
23. Plug should be of proper type to mate to outlet. Never modify the plug in any
way. Adapter plugs should not be used either for grounded power tools. Power
received must be as specified on the drill nameplate.
24. Be sure to connect the plug to a properly grounded receptacle to reduce the
risk of electric shock.
25. To reduce the risk of electrical shock, we recommend the use of GFCI and to
refer servicing to a qualified professional. Avoid body contact with earthed or
grounded surfaces such as metal objects.
26. Before operating, be sure the activated drill will be of no danger to anyone.
Check to make sure all adjusting key or wrench were removed.
27. When machine is plugged in do not leave it unattended. Unplug prior to
servicing, when changing accessories, and when not in use.
28. Never carry machine by cord. Do not pull cord to unplug. Keep cord away
from heat, sharp edges and oil.
29. When using an extension cord, make sure it is in good condition and heavy
enough to carry the current drawn by the machine. Refer to the extension cord
table in the “Electrical Specifications” section for the correct gauge depending
on the desired cord length and the machine’s horsepower and voltage.
30. Service on the drill should only be performed by a qualified technician.
3