Diamond Products UDM - Manual (Page 12)

Light Tower
Use the strobe light to alert others when operating
the machine. Use the spotlight for additional
lighting as necessary.
Lift Points
There are two welded loops, one on each side of the
frame at the rear of the machine, and there is one
shackle near the top of the frame column at the front of
the machine. Secure the lifting cables, straps, and/or
chains to these three points and adjust them so the
overall lift point is near the front axle. Note: The empty
center of gravity is just behind the front axle. This
location will shift toward the rear slightly with a full water
tank.
Fuel System
DO NOT operate the machine with a fuel leak.
DO NOT fuel the machine with the engine running.
DO NOT smoke or expose fuel to open
flames when filling the fuel tank or
working with fuel.
Clean up spilled fuel prior to starting the engine.
Fueling the Machine
1. Turn off the engine and let the machine cool
down.
2. Remove the fuel tank cap.
3. Fill the fuel tank with unleaded gasoline as
necessary. Refer to the engine manual for fuel
ratings and additional refueling information.
4. Replace the fuel tank cap.
Fuel Shutoff Valve
5. Open the shutoff valve to open the fuel lines.
6. Close the shutoff valve to close the fuel lines.
Battery
Ignitable explosive gases are emitted
from the battery. DO NOT expose the
battery to sparks or open flames, and
keep the area around the battery well-
ventilated.
Use a proper battery tester when testing
the battery strength.
Use protective eyewear or a face shield
and avoid any contact with the skin
when handling/servicing the battery
The machine contains a charged battery with one
positive cable lead and one negative cable lead.
Master Battery Disconnect
The master battery disconnect connects or
disconnects the battery’s circuit. Note: The master
battery disconnect must be on prior to starting the
engine.
9