Diamond Products UDM - Manual (Page 25)

Appendix C
Belt Tension Setting
Table 1: Belt Tension Setting
Model Engine Type Deflection Deflection Force
Ultimate Drilling
Machine (UDM)
20.5HP Honda GX670
to 5000 W Alternator
.10” 69 lb
Appendix D
Additional Resources
1. Diamond Products (
www.diamondproducts.com )
• Ultimate Drilling Machine Parts List; Ohio, 2009
A Guide for Professional Concrete Cutters
Training Manual–Introduction to Diamond Blades, Bits, and Equipment
Diamond Products’ Equipment Catalog
Diamond Products’ Website ( www.diamondproducts.com )
2. Honda Motor Company ( www.honda-engines.com )
Owner’s Manual; GX610, GX620, GX670; Japan, 2007
3. Concrete Sawing and Drilling Association (CSDA) ( www.csda.org )
The CSDA has many helpful concrete cutting publications available to members and non-members.
4. Association of Equipment Manufacturers (AEM) ( www.aem.org )
The AEM has a variety of safety and technical manuals available for various types of equipment, along with
a list of industry-standardized safety symbols.
5. Occupational Safety and Health Administration (OSHA) ( www.osha.gov )
OSHA provides information on work-related safety and health practices.
6. The National Institute for Occupational Safety and Health (NIOSH) ( www.cdc.gov/NIOSH )
NIOSH provides information on work-related safety and health practices.
Deflection (in.) should be equal to number of inches listed in chart
above when deflection force (lb.) listed in chart above is applied to
middle of belt using tension gauge.
22