Diamond Products CB66DS User Manual
Page 33
H30 Operation Manual
Houston Street Technologies
13
ESP - DUAL VALVE
A dual-valve feed system is comprised of dual 2-position valves that use one solenoid each to control hydraulic oil
flow, and ultimately the feed direction. The first valve is an ON/OFF valve that controls hydraulic oil flow to the
feed system, while the second valve determines the direction of the feed rollers.
FEED CONTROL
Option to control feed rollers, use OPEN TO RUN to allow
rollers
to feed forward in the event of a relay or solenoid
failure, use CLOSE TO RUN to prevent wheel operation in
the event of a relay or solenoid failure
ENGAGE SPEED
Minimum engine RPM at which the feed rollers will begin
feeding forward
DISENGAGE SPEED
Engine RPM that the feed rollers will reverse
FEED FORWARD
The digital output used to control the feed forward solenoid
FEED REVERSE
The digital output used to control the feed reverse solenoid
REVERSE TIME
Length of time the feed rollers will be reversed
MANUAL FORWARD
Digital input used to manually forward the feed rollers when
the engine is running
MANUAL REVERSE
Digital input used to manually reverse the feed rollers when
the engine is running
To enable/disable ESP:
1) Press ENTER while at the Operation Screen to access the Main Menu.
2) Use U/D buttons to highlight OPERATING MODE and press ENTER.
3) Use U/D buttons to highlight ESP.
4) Use L/R buttons to ENABLE or DISABLE.
(ESP settings can be configured by highlighting CONFIGURE ESP after it has been enabled.)
When purchasing your controller you must specify the feed system that you will be using, controllers do not come
with both the single- and dual-valve system controls enabled.
NOTE: The above operating modes are included in the full feature H30. Your H30 may not include all of the
above operating modes.
SCREENSHOT - ESP DUAL VALVE
ESP SETUP - DUAL VALUE
FEED CONTROL: OPEN TO RUN
ENGAGE SPEED: 2200 RPM
DISENGAGE SPEED: 1800 RPM
FEED FORWARD: D/O#
FEED REVERSE: D/O#
REVERSE TIME: .03 SECONDS
MANUAL FORWARD: D/I#
MANUAL REVERSE: D/I#
RETURN TO OPERATING MODE