Diamond Products FZ-3S - Manual (Page 23)

5.6 Fixing the tracks on concrete
Pay attention to the following in-
structions. Inappropriate fixing
leads to serious hazards!
Always use:
– Ur†v‚vtÃiy‚px†Г%Гv‡uÃhyyÆp r†Ã$
– 9‚ryÃi‚y‡†Ãv‡u)Ñà $Г€€ГhqГ'ÃxIÂsÇ hp‡v‚Ã†rr
Å6ppr††‚ vr†Å
– Tp r†Ã$)Ãyrt‡uГ2Г$Г€€
– ‡‚Г‡ hpxÃih†r†Гs‚ Г‡urÃsv †‡Ã‡ hpxÁ€qÂs‚ ÃhyyÃsˆ ‡ur
‡ hpx†
U hpx
! 8yh€ƒvtÃqr‰vpr
" Ur†v‚vtÁˆ‡
# 6qwˆ†‡vtÆp r
$ 9‚ryÃi‚y‡
% Ur†v‚vtÃiy‚px
& Gˆi vph‡vtÁvƒƒyr
' 6qwˆ†‡vtÆp r
( U hpxÃih†r
Procedure
•
Mark the cutting line
•
Mark the dowel line in sections of 22 cm
(for flush cutting 24 cm)
•
Mount the tracks (1) to the track bases (9).
Distance between track bases:
- as big as possible when using one
track only
- equally distributed along the whole
cutting distance when using more then
one track
Unscrew the adjusting screws (4) until
the track base is at least 2 cm above the
concrete, otherwise the swivel arm will
brush against the concrete.
•
Fix the tracks to the concrete and align
them with a distance of 8 cm (10 cm for
flush cutting) to the cutting line
•
Align the tracks by means of the adjusting
screw (8) so that all adjusting screws are
in contact with the concrete surface.
•
Make sure that the tracks are in true aligne-
ment and without distance at the joints.
•
Mount the track end stopper so that the
wall saw can’t fall off the track.
Fig. fz4-2b.tif
Fig. fz4-3a.tif
Aa"T Tr‡ˆƒ
FZ_39903 Page 23