DoorKing 1808 Telephone Access Plus User Manual
Owner’s manual
Advertising
This manual is related to the following products:
Table of contents
Document Outline
- Table of Contents
- Important Notices
- General Information
- Features
- SECTION 1 - INSTALLATION
- 1.1 Mount the Access Plus Unit
- 1.2 Dimensions
- Surface Mount 1810 Access Plus
- Surface Mount 1810 Access Plus with Recess Box/Trim Ring
- Flush Mount 1810 Access Plus
- Flush Mount Rough-in Box (1810 Access Plus only)
- Flush Mount Trim Ring (1810 Access Plus only)
- Surface Mount Trim Ring for Flush Mount Units (1810 Access Plus only)
- Surface Mount 1808 Access Plus
- Postal Switch Installation (1810 Access Plus only)
- Surge Suppression and Grounding
- 1.9.1 RS-485 Connection
- RS-485 Connections
- 1.9.2 Network Connections
- 1.9.3 Modem Connections
- SECTION 2 – PROGRAMMING
- STOP!
- 2.4 System Parameters Programming
- Programming from the Keypad
- Programming with a Touch-Tone Telephone
- 2.4.1 Single or Multiple Units
- 2.4.2 Single or Double Ring
- 2.4.3 Number of Rings to Ring Residence
- 2.4.4 Talk Time
- 2.4.5 Relay Strike Time
- 2.4.6 Tone Open Numbers
- 2.4.7 Answer Incoming Call on X Rings
- 2.4.8 Hang Up Tone
- 2.4.9 Call Waiting
- 2.4.10 Turn Speaker On
- 2.4.11 Set Microphone Gain and Speaker Volume
- 2.5.1 Directory Codes 01 – 23 1816 Intercom Relay Programming
- 2.5.2 Directory Codes 24 – 50 Dial Phone Number
- 2.5.3 Delete Phone Number from Directory Codes 24 - 50
- 2.5.4 Delete All Phone Numbers from Directory Codes 24 - 50
- 2.6.1 Simple Access Code Programming
- 2.6.2 Number of RS-485 Devices
- 2.6.3 Additional Relay Off-Line Function
- 2.6.4 Device Access Code Programming
- 2.6.5 Delete Device Access Codes
- 2.6.6 Delete All Device Access Codes (of the same type)
- 2.6.7 Temporary Device Access Code Programming
- 2.6.8 Delete Temporary Device Access Codes
- 2.6.9 Delete All Temporary Device Access Codes
- 2.7.1 Program Calendar Chip
- 2.7.2 Relay Hold Schedule
- 2.7.3 Time Zones
- 2.8.1 Restore Defaults
- 2.8.2 Erase Transaction Log
- SECTION 3 – ADJUSTMENTS
- SECTION 4 – USER INSTRUCTIONS
- SECTION 5 – MAINTENANCE