DoorKing 1820 Telephone Intercom User Manual
Owner’s manual
Advertising
Table of contents
Document Outline
- Table of Contents
- General Information
- Section 1 - Installation
- Section 2 - Wiring
- Section 3 – Programming
- 3.1 System Set Up
- 3.1.1 Master Code
- 3.1.2 1982 Relay Board / 1884 Interface Board
- 3.1.3 Last Available Relay
- 3.1.4 Setting the System Time Clock
- 3.1.5 Set the Caller ID Number
- 3.1.6 Set the Talk Time
- 3.1.7 Number of Rings / Ring Type
- 3.1.8 Tone Open Number Programming
- 3.1.9 Relay Strike Time
- 3.2.1 Programming Directory Codes
- 3.2.2 Turning Programmable Directory Codes On / Off
- 3.2.3 Directory Code for Doorman/Concierge to Lobby Panel
- 3.2.4 Erasing All Programmed Directory Codes
- 3.3.1 Doorman/Concierge Outside Line Access
- 3.3.2 Preprogrammed Phone Numbers
- 3.3.3 Erase Preprogrammed Phone Number
- 3.3.4 Erase All Preprogrammed Phone Numbers
- 3.4.1 Programming Entry Codes
- 3.4.2 Erasing Individual Entry Codes
- 3.4.3 Erasing All Entry Codes
- 3.5.1 Do Not Disturb Feature On / Off – System Wide
- 3.5.2 Set 1-Time Do Not Disturb Timer for Resident(s)
- 3.5.3 Scheduled Do Not Disturb On / Off
- 3.5.4 Setting Do Not Disturb Schedule
- 3.6.1 Set Up for Call Forwarding - System Wide
- 3.6.2 Call Forwarding On / Off per Resident
- 3.6.3 Program Call Forward Numbers
- 3.6.4 Delete Call Forward Numbers
- 3.6.5 Program Call Forward Allowed Area Codes
- 3.6.6 Delete Call Forward Allowed Area Codes
- 3.6.7 Delete All Call Forward Allowed Area Codes
- 3.7.1 Virtual Doorman On / Off – System Wide
- 3.7.2 Set Virtual Doorman Relay Strike Time
- 3.7.3 Virtual Doorman On / Off per Resident
- 3.8.1 Call-Down Feature On / Off – System Wide
- 3.8.2 Set Doorman to Enable / Disable Direct Connect
- 3.8.3 Set Direct Connect Disable Timer
- 3.8.4 Set Direct Connect Call-Down Number
- 3.8.5 Set Resident Programming Number
- SECTION 4 – OPERATING INSTRUCTIONS
- 4.1 Administrator and Doorman Commands & Functions
- 4.1.1 Lobby Panel On / Off
- 4.1.2 Calling the Lobby Panel
- 4.1.3 Accessing the Outside Phone Line
- 4.1.4 Calling Preprogrammed Telephone Numbers
- 4.1.5 Calling the Doorman or Lobby Panel from an Off Site Location
- 4.1.6 Lobby Panel Relay Activation
- 4.1.7 Calling a Resident without C.O. Phone Service from an Off Site Location
- 4.1.8 Turn Direct Connect On / Off
- 4.1.9 Call Back a Resident
- 4.1.10 Clear Call Back Number or Queue
- 4.2.1 Reset Main Control Board
- 4.2.2 Reset Main Control Board Resident Programming
- 4.2.3 Set Touch-Tone Detect Time
- 4.2.4 Reset Line Interface Board Programming
- 4.2.5 Send Software Reset to All Line Interface Boards
- Appendix