Nova-Tech 4180-4181 TRACEABLE PRINTING HYGROMETER_THERMOMETER - Manual (Page 2)

Traceable
®
is a registered trademark of Control Company.
©2007 Control Company . 92-4181-00 Rev. 1 121707
the setting is finished. Press or button to select
parameter setting, press or button to increase or
decrease the parameter.
Parameter setting in sequence and LCD display as
follows:
Parameter function ON or OFF select 1.
Interval printing “second” parameter setting. 2.
Interval printing “minute” parameter setting. 3.
Printing start time “minute” parameter setting. 4.
Printing start time “hour” parameter setting. 5.
Printing stop time “minute” parameter setting. 6.
Printing stop time “hour” parameter setting. 7.
Calendar “minute” parameter setting. 8.
Calendar “hour” parameter setting. 9.
Calendar “day” parameter setting. 10.
Calendar “month” parameter setting. 11.
Calendar year last two digit parameter setting. 12.
HOW TO SETuP INTErVAL PrINT
Setup Interval print with 24 hours limitation. 1.
Press 2. Key to enter setting mode, setting print
operation is ON.
Select interval printing time setting mode, set “sec-
3.
ond”, “minute” (from 00:06 to 59:59).
Select start printing time setting mode, set “minute”,
4.
“hour” (from 00:00 to 23:59).
When finish the setting, press
5. key to exit the
setting mode, LCD will display “ ” mark at left
upper corner.
Note: The start time must be earlier than the stop time,
otherwise the buzzer will beep to warning the setting is
error and not accept the setting when press key.
BATTErY rEPLACEmENT
As battery power is not sufficient 1. will be shown
on LCD. Replace with 6 pcs new of 1.5V size AAA
batteries is required.
After the temperature probe is disconnected and the
2.
meter is powered off, remove the battery cover.
Remove batteries from the holder and replace it with
3.
6 pcs of new 1.5V size AAA alkaline batteries.
Secure the battery cover
4.
ACCESSOrIES
Cat. No. 8182 Paper Rolls (2/pk)
Cat. No. 8183 AC Power Supply
Warranty, service, or
recalibration
For warranty, service, or recalibration, contact:
Control Company
4455 Rex Road
Friendswood, Texas 77546 USA
Ph. 281 482-1714
Fax 281 482-9448
E-mail [email protected]
www.control3.com
Control Company is ISO 9001
Quality-Certified by DNV and
ISO 17025 accredited as a
Calibration Laboratory by A2LA.
traCeable
printing
Hygrometer/
tHermometer
instruCtions
®