Pach and Company AeGIS NPB9000 Series Manual - Manual (Page 24)

Pach and Company Chapter 3 Page 16
AeGIS NPB9000 Series PROGRAMMING 05/01/02
FUNCTION CODE LOCAL PROGRAMMING
NOT APPLICABLE FOR NO PHONE BILL
Step 1 Log on to programming mode (see section 3.1). The display shows
Step 2 Enter Function Code 10 then press # and If relay 2 is set as a DOOR
CONTROL in Function Code 08 the display shows
If relay 2 is set other than a Door Control, proceed to step 4.
Step 3 Enter 1 for relay 1 (door 1) or 2 for relay 2 (door 2) then press #, the display
shows
Step 4 Enter 01-98 (unlock 1-98 hours) or 99 (unlock hold) then press #, the
display shows
Step 5 Select another Function Code to program different field from the table or
press * to exit the programming mode.
Step 1 Log on to programming mode (see section 3.1). The display shows
Step 2 Enter Function Code 11 then press # and the display shows
09
ALARM TELEPHONE NUMBER
NOT APPLICABLE FOR NON
SUBSCRIBER
10
MANUAL UNLOCK/LOCK OR
UNLOCK HOLD DOORS TIMER
Set the timer to unlock/lock or unlock
hold relay 1(door 1) or relay2 (door
2).
01-98 hours - doors will unlock and
lock for 01 - 98 hours.
99 - doors will unlock for indefinite
time (unlock hold).
11
EDIT WELCOME MESSAGE
DISPLAY
The welcome screen is a scrolling
display. A total 48-characters (16 -
characters for each segment) can be
programmed for the welcome
message.
SELECT PROGRAM
ENTER: _ _ PRESS #
Set Which relay
(1 or 2): _
HOURS UNLOCK
ENTER: _ _ PRESS #
SELECT PROGRAM
ENTER: _ _ PRESS #
SELECT PROGRAM
ENTER: _ _ PRESS #
Welcome to Pach’
MESSAGE SEGMENT 1