Pach and Company AeGIS NPB9000 Series Manual - Manual (Page 43)

HOW TO EXTEND THE
TALK TIME
HOW TO USE THE
CALL WAITING
HOW TO USE THE
DOORMAN OR
MANAGER PHONE
HOW TO USE THE
KEYPAD ACCESS CODE
HOW TO USE THE
CARD ACCESS OR
RADIO TRANSMITTER
The talk time can be programmed from 10 - 240 seconds. You will hear “ One Long
Beep” ten seconds before the talk time expires. The tenant must press #
immediately to extend the talk time to another cycle. For example: if the talk time is set
for 30 seconds, pressing # will extend for another 30 seconds. You can continue
pressing the # to extend the talk time after the “ One Long Beep”.
Press 0 on your phone keypad to answer the incoming call and put the exsiting call on
hold. NOTE: WORKS ONLY ON TONE PHONE.
To Place a call to tenant: press # then the 4-digit phone number (relay number, not
tenant actual phone number.
To Place a call using the outside line: because your phone is connected as a
doorman or manager phone, to place a call
using the outside line you must press 0 then
dial the phone number (actual phone number).
NOTE: WORKS ONLY ON TONE PHONE.
Step 1 Press * then the screen stops scrolling, if the screen is still scrolling, repeat this
step.
Step 2 Press a valid keypad access code and the door will unlock. If the keypad
access code is invalid the display shows
NOTE: If invalid codes are entered more than the number program on
Function Code 03, the display shows
the system will ignore further keypad access code entries for 90
seconds. If a telephone number is programmed on Function Code 09,
the display shows
and will call the number
programmed
Step 1 Place the card close enough to the red light emitting diode (LED) on the reader
or press the radio transmitter button
Step 2 The Card Reader will beep if the card is read properly and the green LED
blinks, the door will unlock if the code is valid or the display shows
NOTE: If invalid card access is used more than the number program on
Function Code 03, the display shows
If a telephone number is programmed on Function Code 09, the display shows
and will call the number
Pach and Company Chapter 4 Page 35
AeGIS NPB9000 Series SYSTEM’S OPERATION 05/01/02
ERROR Wrong Code
PLEASE TRY AGAIN
INVALID CODE! !
ACCESS DENIED
ERROR Wrong Code
PLEASE TRY AGAIN
INVALID CODE! !
ACCESS DENIED
ALARM ACTIVATED
ALARM ACTIVATED