AT&T DECT TL91278 - Manual (Page 25)

Bluetooth
Bluetooth setup
To resume the auto connection
To resume the auto connection between the
paired device and the telephone base, you will
need to connect the device manually. Make sure
the Bluetooth feature is turned on in your cellular
phone. Select
AT&T DECT 6.0 from the paired
device list in your cellular phone to reconnect.
If the connection is successfully resumed, the
status icon will display on the cordless handset
screen, and the light of the
Bluetooth button on
the telephone base will be on steadily.
Replace a paired device
If you want to pair and connect a new device when
there is already a device paired with the telephone
base, press and hold the
Bluetooth button on the
telephone base until it is flashing, then start with
step two of
Pairing a device on page 18. If you
do not pair a new device within two minutes, the
Bluetooth light on the telephone base will turn off
and the system will return to idle mode.
NOTE: If the connection
between the paired
device and the telephone
base does not resume by
manually connecting the
device on the paired
device list, you will need
to unpair or deregister
the device from the
cellular phone. Make
sure the device is no
longer on the paired list
after deregistration; then
follow the steps in
Pairing a device on
page 18 to start the
pairing procedures again.
20