A&D Weighing Indicator AD-4405 - Manual (Page 44)

Page 42 AD-4405 Weighing Indicator
F22 = 9 (Check weighing 3:Loss in weight) F22 = 9 (Check weighing 3:Loss in weight) F22 = 9 (Check weighing 3:Loss in weight) F22 = 9 (Check weighing 3:Loss in weight)
Output and Condition Output and Condition Output and Condition Output and Condition
* Relay OK output can be changed to OVER or UNDER by setting f24.
Triangle 2 is displayed when Gross
] Full regardless of the f24 setting.
OVER/UNDER is judged always and the result is output to the LED and the relay.
10.2.2. Simple Batch
The weighing sequences of simple batch (f22 10, 11 or 12) are similar to those of
Check weighing (f22 7, 8 or 9) respectively. The differences are listed below.
1 Basically ON/OFF of the relay and the LED are reversed.
2 No judgment other than Zero band and Full before input of the Start signal.
3 The weighing completion condition is set by f23 2x and it is effective after Start.
4 The outputs of Preliminary and Free fall are off from weighing completion to the
next start.
5 Weighing completion can be output by setting f24 and f25.
6 The start signal can be accepted after weighing completion even if the weight is
not within the zero band.
7 Over/Under output is set by f23 3x.
Start Start Start Start
Tare, when the Start is input automatically if f23 11.
The READY mark turns off when the Start is input.
Weighing Completion Weighing Completion Weighing Completion Weighing Completion
The weighing completion condition is set by f23 2x.
f23 20 : Either the STOP key is pressed or the Batch stop input is on.
f23 21 : Stable is detected after reaching Final.
Before reaching Final, the STOP key or Batch stop input forces weighing
completion even if f23 21.
10.2. Setpoint Comparison
Final
Weighing value
Calibrated Zero
Tare
Tared Zero
Zero band
Free fall
Preset target weight
Time
Weighing
Relay HI, 1, -Net
]
- (Final - Free fall)
Relay OK*, 2, Gross
]
Full
Relay LO, 3, Gross
¢ Zero band
ON
ON
ON ON
OFF
OFF
OFF
OFF
OFF
OFF
ON