AT&T 1231 - Manual (Page 5)

7
Getting Started
6
Getting Started
Battery installation & charging
After installation, place the handset in the base or charger and allow to charge for 12
hours before use. You can keep batteries charged by placing the handset in the base or
charger after each use. When batteries are fully depleted, a recharge takes about 10 hours.
Press coin into slot on
base of handset to
release latch, then
remove cover
Insert supplied
batteries
Place handset in base or charger
to charge for 12 hours before
first use.
Telephone base & charger installation
Install the base and charger as shown below. Choose a base location away from
electronic equipment, such as personal computers, television sets or microwave ovens.
Avoid excessive heat, cold, dust or moisture.
Plug base power cord
transformer into
electrical outlet
Plug long telephone
line cord into
telephone jack
Low battery indicator
Return handset to base or charger
when this symbol flashes. (Handset
will beep when battery is low.)
NOTE: Use only the power
cord supplied with this product.
If you need a replacement, call
1-800-222–3111.
Be sure to use an electrical outlet
not controlled by a wall switch.
Caution: Use only supplied
rechargeable battery or AT&T
replacement battery model 2419
/ 2420 (sku 00578).
Insert top
tabs first
Press down to
click in place
Plug charger power cord into jack on
underside of charger, then plug
transformer into electrical outlet
LOW BATTERY