Bosch BSG82502 kirschrot-metallic Bodenstaubsauger Beutel ergomaxx pro. hard floor 2500 - Manual (Page 39)

38
en
Fold out picture pages.
Setting up
Figure
a) Insert the flexible hose adapter into the air intake open-
ing and allow it to engage.
b) To remove the flexible hose, press the two lugs together
and pull the tube out.
Figure
a) Align and connect the handle and the telescopic tube.
b) Push the handle straight into the telescopic tube until it
engages.
To release the connection, squeeze the collar sleeve and
pull the handle out.
Figure
Push the telescopic tube straight into the
connecting piece of the floor tool until it engages.
To release the connection, squeeze the locking collar
and pull the telescopic tube out.
Figure
Press the adjusting sleeve in the direction of the
arrow and adjust the telescopic tube to the length
required.
Figure
Fasten the accessory holder to the suction pipe and
insert the combination tool from above.
Figure
Holding the power cord by the plug, pull out the required
length and plug the plug into the mains socket.
Figure
To switch your vacuum cleaner on and off, press the
On/Off button in the direction of the arrow.
7
6
5
4*
3*
2*
1
Vacuuming
You have bought an extremely powerful device. The high-
est suction setting is therefore only recommended for
heavily soiled, short-pile carpets and hard floors.
Figure
The required suction power can be selected by adjusting
the suction regulator.
Ⅲ Low
suction range:
For vacuuming delicate fabrics, e.g. curtains.
Ⅲ Moderate
suction range:
For daily vacuuming of lightly soiled floors.
Ⅲ High
suction range:
For vacuuming durable floor coverings, hard floors and
for heavily soiled surfaces.
Ⅲ Turbo range:
For vacuuming stubborn dirt and very heavily soiled sur-
faces.
Figure
Adjusting the floor tool:
a) For vacuuming rugs and carpets
=>
b) For vacuuming hard floors =>
Caution!
Floor tools are subject to a certain amount of wear,
depending on the type of hard floors you have
(e.g. rough, rustic tiles). Therefore, you must check
the underside of the floor tool at regular intervals.
Worn undersides of floor tools may have sharp edges
that can damage sensitive hard floors, such as parquet
or linoleum. The manufacturer does not accept any
responsibility for damage caused by worn floor tools.
Vacuuming with accessories
Figure
Remove the combination tool upwards
out of the accessory holder.
a) Crevice nozzle
For vacuuming in crevices and corners.
For difficult-to-reach places, the combination tool
can be extended in two stages by pulling out the
crevice nozzle like a telescope.
Ⅲ Pull out the crevice nozzle in two stages until it audi-
bly clicks into place.
Ⅲ The crevice nozzle can be pushed back together by
releasing the telescopic locks (press in the direction
of the arrow).
b)Upholstery nozzle
For cleaning upholstered furniture, curtains, etc.
10
9
8
Innenteil 5100 003 289 A 06.02.2013 15:11 Uhr Seite 38