Bosch TES803F9DE VeroSelection exclusiv Kaffeevollautomat Front Edelstahl Gehäuse hochglanz anthrazit - Manual (Page 53)

49
TES803F.. | 04/2013
en
Problem Cause Solution
The coffee tastes “burnt”. Brewing temperature too
high
Reduce the temperature, see
“Menu settings – Coffee temp. ”
The grinding setting is
too fine or the pre-ground
coffee is too fine.
Adjust the grinding unit to a
coarser setting or use coarser
pre-ground coffee.
Unsuitable type of coffee. Change the type of coffee.
Display shows
Error
Please contact hotline
The appliance has a fault. Please contact the hotline.
The water filter does not
stay in position in the
water tank.
The water filter is not
mounted correctly.
Firmly press the water filter
straight down into the tank
connection.
Display shows
Check water tank
Water tank has been
incorrectly inserted or the
new water filter has not
been rinsed according to
instructions.
Insert the water tank correctly or
rinse the water filter according to
instructions and then switch on.
The coffee grounds are
not compact and are too
wet.
The grinding setting is too
fine or too coarse, or not
enough
ground coffee has been
used.
Adjust the grinding unit to a
coarser or finer setting, or use
2 level measuring spoons of
ground coffee.
Display shows
Clean brewing unit
Brewing unit is soiled. Clean brewing unit.
Too much pre-ground
coffee in the brewing unit.
Clean brewing unit (pour in no
more than 2 level measuring
spoons of ground coffee).
The brewing unit’s
mechanism is stiff.
Clean brewing unit (see “Mainte-
nance and daily cleaning”).
Coffee or milk froth quality
varies considerably.
Build-up of limescale in the
appliance.
Descale the appliance with two
descaling tablets as described
in the instructions.
Water dripped onto the
inner floor of the appli-
ance when the drip tray
was removed.
Drip tray removed too
early.
Wait a few seconds after the
last drink was dispensed before
removing the drip tray.
If you are unable to solve the problem, always call the hotline!
You will find the telephone numbers at the back of these instructions.
TES803F_MK.indb 49 08.05.2013 12:21:15