Bosch TES50651DE VeroCafe LattePro Kaffeevollautomat Helles Anthrazit Morning Haze - Manual (Page 32)

28
Robert Bosch Hausgeräte GmbH
en
aromaDouble Shot
The longer the coffee is brewed, the more
bitter substances and undesired aromas
are released. This has a negative effect on
the taste and makes the coffee less easily
digestible. So for extra strong coffee the
TES506 has a special aromaDouble Shot
function. When half the quantity has been
prepared, coffee is ground and brewed
again so that only the pleasant, aromatic
scents are released.
The aromaDouble Shot function is activated
with the following settings:
Before using
for the first time
General
Fill the appropriate container using only
pure, cold, uncarbonated water and only
roasted beans (preferably espresso or cof-
fee bean blends for fully automatic coffee
machines). Do not use coffee beans that
have been glazed, caramelised or treated
with other additives containing sugar, since
they will block the brewing unit.
The water hardness setting can be adjusted
on this appliance. The factory default set-
ting for the water hardness is 4. Check the
water hardness with the enclosed test strip.
If the check reveals a value other than 4,
change the setting on the appliance accord-
ingly after switching on (see “Menu settings”
Water hardness ).
Switching on the appliance
1. Remove the protective film.
2. Place the fully automatic espresso
machine on a flat, water­resistant
surface that can take its weight. Make
sure that the machine’s ventilation slots
remain unobstructured.
Important: Only use the appliance in
frost-free rooms. If the appliance has been
transported or stored at temperatures below
0 °C, wait at least 3 hours before operation.
3. Pull the power cord out of the storage
compartment (21) and plug in. Adjust
the length of the cable by pushing it
back in or pulling it out. The easiest way
to do this is to place the appliance so
that its back is flush with the edge of the
counter and either pull the cable down-
ward or push it upward.
4. Install the milk frother. Operate the
machine only after the milk frother (6)
has been fully assembled and installed.
5. Lift the lid of the water tank (18).
6. Remove and rinse the water tank (17)
and fill it with fresh cold water.
Do not fill above the max mark.
7. Replace the water tank (17) and push it
firmly downward into place.
8. Close the lid of the water tank (18)
again.
9. Fill the bean container (1) with cof-
fee beans (for preparation using
ground coffee, see “Preparation using
ground coffee”).