Preparation using ground coffee, Dispensing hot water – Bosch TES50651DE VeroCafe LattePro Kaffeevollautomat Helles Anthrazit Morning Haze User Manual

Page 36

Advertising
background image

32

Robert Bosch Hausgeräte GmbH

en

N.B.: With some settings the coffee

is prepared in two stages (see

“ aromaDouble Shot”). Wait until the proce-

dure is fully completed.

Press the

start button (10) again to cut the

brewing process short.

Preparation using

ground coffee

This fully automatic espresso machine can

also be operated with ground coffee (not

instant coffee powder).

The appliance must be ready for use. To

prepare a coffee­based drink with milk, first

insert the milk tube into a milk container and

turn the rotary selector (6b) to “Milk froth”

j

.

N.B.: The aromaDouble Shot function can-

not be used when coffee is prepared using

ground coffee.

Important: Dried milk residue is difficult

to remove, so the milk frother (6)

must be

cleaned with lukewarm water immediately

after use and rinse using the

Rinse milk

system

programme.

Important: Fill the water tank (17) with

fresh water every day. The tank (17) should

always contain sufficient water for operating

the appliance.

Preparation

1. Open the drawer (4).

2. Pour in no more than 2 level measuring

spoons of ground coffee.

Warning: Do not use whole beans or

instant coffee.

3. Close the drawer (4).

4. Select the required drink by turning the

upper rotary knob (15) (only one cup

possible).

5. Press the

start button (10).

Coffee is brewed and then poured into

the cup.

N.B.: Repeat the procedure for another

cup of coffee. If no coffee is taken within

90 seconds, the brewing chamber emp-

ties automatically to avoid overfilling. The

appliance rinses.

Dispensing hot water

¡

Risk of burns!

The milk frother (6) gets very hot. Hold the

milk frother (6) by the plastic part only.

The milk frother must be cleaned before

drawing hot water.

The appliance must be ready for use.

1. Place the pre-warmed cup or glass

under the outlet of the milk frother (6).

2. Set the rotary selector (6b) to the

horizontal position.

3. Press and hold the

h

/

g

button (12)

for approx. 3 seconds. The appliance

heats up. Hot water runs out of the milk

frother outlet (6) for about 40 seconds.

4. Press the

h

/

g

button (12) again to

cut the process short.

Advertising