Poweramp CM SERIES MECHANICAL 12.2006 - Manual (Page 18)

INSTALLATION
16 4111-0006 — July 2006
21. Pull the release ring to raise platform. Engage the
platform maintenance prop (B) in the service
(upright) position and lock the maintenance prop
at this position using an OSHA approved locking
device (D). Engage lip maintenance prop.
A— Safety Leg Chain Pull Ring B— Platform Maintenance Prop C — Shim Location (Under Lift Arm Pivot) D — Locking Device
25. Remove the lifting brackets from the platform side
joists.
26. Disengage the platform maintenance prop.
27. Slowly walk out onto the platform to lower the
platform until it is at the cross-traffic (stored)
position.
28. Check operation of dock leveler by cycling the
leveler at least four times.
• When the platform is at full height, lip will be
fully extended.
• Lip will begin to drop after full height is
reached, taking approximately 12 seconds to
fully fold.
29. Check below-dock position by walking platform
down before lip folds completely.
• Lip will be over lip keepers.
• Platform safety legs will be resting on frame.
30. Check full below-dock position by walking the
platform down. Pull and hold safety leg chain (A)
before lip folds completely.
31. If the lip does not extend fully or lip folds too
quickly, see appropriate symptom in the
Troubleshooting section.
32. Install the dock bumpers as required.
22. Install shims under lift arm at locations (C) using
the pyramid shimming method. The lift arm pivot
must be solidly shimmed the entire length of the
lift arm pivot. Make sure the lift arm pivot is level
from side-to-side.
23. Finish weld all shims using a fillet weld.
• Weld all shims within each shim stack to each
other, then weld the shim stack to the leveler
frame.
• Weld the front leveler frame shim stacks to the
front pit curb steel if not done previously.
24. When all welding has been completed, remove all
slag then paint all the welds and shims.
Make sure the platform is properly supported in the
raised position before entering the pit to finish weld
the shims. Failure to do this may result in serious
personal injury or death.
B
D
A
C