PSA PIN388D/PIN388L Installer Manual - Manual (Page 12)

PINKERTON Installer Manual 11
PINKERTON O PERATION
K EYPAD K EY F UNCTIONS
After a code is entered or the

key is pressed, you have 10
seconds to select the operation you wish to perform. During this
time all 8 Zone lights will flash to indicate that a key should be
pressed. If no key is pressed within 10 seconds, the keypad will
revert to idle mode. Enter the code to start again.
The key is always used as "clear key" to abort the current operation.
O PERATION OF ALL KEYS
PANIC
Key

Enter a User Code followed by

or enter
 
to trigger the Panic function. The Panic
function can trigger the siren, strobe light or dialler as programmed by your installer at address
088.
DURESS
Key

Enter a User Code followed by

or enter
 
to trigger the Duress function. The Duress
function can trigger the siren, strobe light or dialler as programmed by your installer at address
086.
TEST
Key

Enter a User Code followed by

or enter
 
to trigger the Test function. The Test function
is used to test the dialler by sending a test transmission to the programmed telephone numbers.
This function is only available if your system is programmed to report alarms to a monitoring
station.