PSA PIN388D/PIN388L Installer Manual - Manual (Page 14)

PINKERTON Installer Manual 13
REVIEW

Previous Events (Miscellaneous)
While in REVIEW mode, pressing Key

displays:
Zone
Light Meaning
1
Siren has been turned on.
2 Strobe has been turned on.
3 Dialler has been triggered.
4 Dialler failed (reached max. attempts).
5 (Not used)
6 Maximum code attempts activated.
7 Low battery has turned off siren (and strobe).
8 Answered phone.
W ALK T EST
Key

Selecting this operation whilst the alarm system is off will initiate walk-test mode. Walk-test can
only be performed by holders of user codes 0 to 7. Walk-test mode allows all Zones and the siren
and the strobe to be tested. Operation is as follows:
When walk-test mode is first entered, all 8 Zone lights will be off. The AC Fail light will show
whether AC is present or not. The Low Batt light will show whether the battery charging voltage
is adequate.
As Zones are triggered the siren will squawk and the relevant Zone light will turn on and remain
turned on. This allows a "one man" walk-test by walking through all Zones.
Pressing the

key turns off all Zone lights and allows the test to be repeated, if required.
S
IREN AND STROBE TEST .
While in test mode:
Pressing the

key will turn on the siren.
Pressing the

key will turn on the strobe.
This enables you to check the individual operation of the siren and strobe. Pressing the

key
will turn off the siren and strobe.
Press the key to exit walk-test.
Please Note: If the siren and strobe are being tested in the Mode and activation of a zone
will deactivate their respective output.