Alliance Laundry Systems UF35PV User Manual

Page 17

Advertising
background image

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT

Operation

15

F232059

WE-6 Microcomputer

The WE-6 microcomputer control is a field-
programmable solid-state control capable of storing
and running up to 39 preprogrammed ready-to-use
cycles.

Cycle 01 is a test cycle used to verify proper operation
of the machine. With the exception of Cycle 39, the
remaining cycles are complete wash cycles or
specialty cycles designed to handle various fabrics at
specific water temperatures and levels. Cycle 39 is
designed to test an external chemical injection supply
system.

A detailed description of the cycles can be found in the
Programming section of this manual under
Preprogrammed Cycles. (If this washer-extractor’s
computer has been equipped with special
preprogrammed cycles, a separate insert listing these
cycles has been included in the resealable plastic bag
which contained this manual.)

Never turn the power off while the computer mode
switch is in the PROGRAM position. Such action will
disorder portions of the programmed data,
necessitating reprogramming of some or all of the
existing cycles. Always return the mode switch to
RUN position before turning the power off.

Never leave the mode switch key inserted in the switch
lock where it may be accessible to unauthorized
personnel not familiar with programming procedures.

The computer control in this washer-extractor is
continuously on the alert for problems within the
machine. When the computer detects a problem, it
immediately flashes a letter or number or both on the
display. It may activate the signal buzzer as well.

LED Display

The WE-6 microcomputer has a six-digit LED display.
References to display indications pertain to the first
four digits of the display, reading left to right. The last
two digits on the right side of the display will indicate
either the last cycle used or the current cycle in
progress. Refer to Figure 3.

Figure 3

U151R

1

Function Being Executed

2

Step Number

3

Cycle Number

1

2

3

Advertising
This manual is related to the following products: