Alliance Laundry Systems UF35PV - Manual (Page 22)

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Operation
F232059 20
Start-Up
Turn on the main power source (circuit breaker or cut-
off switch on the wall).
When AC power is turned on, the front panel display
will show the program (ROM) identification code.
This identification code will appear for approximately
five seconds. Then the computer display will flash
“POWER” and “WAIT” alternately for two minutes.
The display will then show “NEXT00” to indicate that
a cycle can be selected. This display will be shown at
all times that power is on between cycles, indicating
that the door-unlock solenoid will function if the door-
unlock button is pressed. The washer-extractor is then
ready for loading and unloading.
Opening Door
Use left hand to press and hold the door-unlock button
located on the top of the doorbox cover. Use right hand
to turn door handle upward and swing the door right to
open. Refer to Figure 5.
Figure 5
Loading
Load the washer-extractor to full capacity whenever
possible, but do not exceed the rated dry-weight
capacity of the machine if the fabric to be washed is
quite dense, closely woven, and heavily soiled.
Overloading can result in an inferior wash. The
operator may need to experiment to determine load
size based on fabric content, soil content, and level of
cleanliness required.
Partial loads can cause greater machine wear than full
loads. Partial loads, if necessary, should only occur at
the end of the day.
When loading is complete, ensure that all fabric is
inside the basket. Then close and lock the door.
NOTE: When washing items which may
disintegrate or fragment, such as mop heads or
sponges, use laundry nets to prevent drain
blockage.
U153R
U153R
Be careful around the open door,
particularly when loading from a level
below the door. Impact with door edges
can cause personal injury.
SW025
CAUTION