Acer Altos G540 Series - Manual (Page 57)

47
To install an easy-swap hard drive:
1 Remove the side panel from the chassis.
Go to page 39 for instructions.
2 Observe steps 2 through 5 of the previous section.
3 Connect the easy-swap HDD cables.
(1) Connect the power connectors of the SAS/SATA2 cable to the
power supply module HDD power cables.
(2) Connect the data connectors of the SAS/SATA2 cable to the
signal connectors of the of the easy-swap HDDs.
(3) Connect the other end of the SAS/SATA2 power cable to the
SAS1-1 connector of the SAS controller board.
4 Observe the post-installation instructions described on page 38.
5 Set up the new hard drive’s RAID configuration.
For related instructions, go to the “RAID configuration utilities”
section on page 114.