Teledyne 2010A - Split architecture thermal conductivity analyzer - Manual (Page 14)

Teledyne Analytical Instruments 1- Part
1 Introduction
Model 2010A
Figure 1-: Model 010A Rear Panel
• Power Connection 85-250 V AC power source.
• Analog Outputs 0-1 V dc concentration plus 0-1 V dc
range ID, and isolated 4-20 mA dc plus
4-20 mA dc range ID.
• Alarm Connections 2 concentration alarms and 1 system
alarm.
• RS-232 Port Serial digital concentration signal out-
put and control input.
• Remote Probe Used in the 2010A to interface the ex-
ternal Analysis Unit.
• Remote Span/Zero Digital inputs allow external control of
analyzer calibration.
• Calibration Contact To notify external equipment that in-
strument is being calibrated and read-
ings are not monitoring sample.
• Range ID Contacts Four separate, dedicated, range-identifi-
cation relay contacts (01, 02, 03,CAL).
• Network I/O Serial digital communications for local
network access. For future expansion.
Not implemented at this printing.
Note: If you require highly accurate Auto-Cal timing, use external