Teledyne 2010B - Split architecture thermal conductivity analyzer User Manual

Page 15

Advertising
background image

Part I 1-7

Teledyne Analytical Instruments

Thermal Conductivity Analyzer

Part I: Control Unit

•

Alarm Connections

2 concentration alarms and 1 system
alarm.

•

RS-232 Port

Serial digital concentration signal output
and control input.

•

Remote Probe

Used in the 2010B to interface the
external Analysis Unit.

•

Remote Span/Zero

Digital inputs allow external control of
analyzer calibration.

•

Calibration Contact

To notify external equipment that
instrument is being calibrated and
readings are not monitoring sample.

•

Range ID Contacts

Four separate, dedicated,
range-identification relay contacts (01,
02, 03,CAL).

•

Network I/O

Serial digital communications for local
network access. For future expansion.
Not implemented at this printing.

Note: If you require highly accurate Auto-Cal timing, use external

Auto-Cal control where possible. The internal clock in the
Model 2010B is accurate to 2-3 %. Accordingly, internally
scheduled calibrations can vary 2-3 % per day.

Advertising