Teledyne BDS-3000 - Oxygen analyzer - Manual (Page 38)

Installation BDS 3000
Teledyne Analytical Instruments 24
Table 3-1: Analog Output Connections
Pin Function
3 + Range ID, 4-20 mA, floating
4 – Range ID, 4-20 mA, floating
5 + % Range, 4-20 mA, floating
6 – % Range, 4-20 mA, floating
8 + Range ID, 0-1 V dc
23 – Range ID, 0-1 V dc, negative ground
24 + % Range, 0-1 V dc
7 – % Range, 0-1 V dc, negative ground
Alarm Relays: The nine alarm-circuit connector pins connect to the
internal alarm relay contacts. Each set of three pins provides one set of
Form C relay contacts. Each relay has both normally open and normally
closed contact connections. The contact connections are shown in Table
3-2. They are capable of switching up to 3 amperes at 250 VAC into a
resistive load. The connectors are:
Threshold Alarm 1:
•
Can be configured as high (actuates when concentration
is above threshold), or low (actuates when concentration
is below threshold).
•
Can be configured as failsafe or nonfailsafe.
•
Can be configured as latching or nonlatching.
•
Can be configured out (defeated).
Threshold Alarm 2:
•
Can be configured as high (actuates when concentration
is above threshold), or low (actuates when concentration
is below threshold).
•
Can be configured as failsafe or nonfailsafe.
•
Can be configured as latching or nonlatching.
•
Can be configured out (defeated).