Emergi-Lite Mini Revelation Battery Series - Manual (Page 3)

Emergi-Lite
Tel: (888) 552-6467 ext. 547 or 255 Fax: (888) 867-1565 www.emergi-lite.com
MINI Retract-Lite: Concealed Emergency Lighting
3/4
08/08 750.1322 Rev. B
13. Hold the unit with one hand; disengage the two hooks and secure
them to the unit housing.
14. Turn the unit to normal position, with the transformer box at the bot-
tom.
15. Force the door of the lamp module half-open to hold the unit and
locate the four key holes in its housing (see Figure 5).
16. Push the electrical cable and the unit into the wall, and engage the
key holes of the lamp module onto the four screws of the "U" bracket.
Slide the lamp module so that the heads of the screws are in the slotted
end of the key holes (see Figure 6).
17. Align the unit frame then tighten the four screws until the trim is flush
with the drywall surface. For easy access to the screws, the door can be
rotated one full turn of 360 degrees.
18. Orient the two lamps in their swivels and check that they are plugged
into the sockets.
19. Close the door and make sure it is flush with the trim.
Equipment installation in an open ceiling
1. Suspend the unit upside-down, from the "U" bracket using the metal
hooks. Secure the unit with the chains or "pencil rod" wires. Continue by
following the steps 2 to 19 above.
Testing the Equipment
Self-powered equipment
1. Activate the AC power.
2. The recessed pilot light/test switch will light in green.
3. Allow 24 hours to fully charge the batteries.
4. Push the test button. The door will open and the lamps will illuminate
for one minute, then the door will close. Orient the lamps to the desired
position at this time. If more time is needed, push the test button again,
for 5 to 10 seconds. This will ensure a test duration of three minutes.
AC-only equipment, powered from a remote AC generator
1. Activate the AC power generator. The equipment door will turn and
open, then the lamps will illuminate. Orient the lamps to the desired posi-
tion at this time.
2. Disable the AC generator. The lamps will turn off and the equipment
door will turn and close.
Maintenance
The equipment requires no maintenance, but should be tested regularly
in accordance with the local codes.
Figure 6a
Figure 6b
Key
holes
Figure 5