Fairbanks BlueLineFS Scale System - Manual (Page 21)

8/09 21 51198 Rev. 2
Section 5: Service & Maintenance
INDICATOR ERROR CODES
There are several error conditions and operational steps indicated by the scale.
• Not all are applicable in every sequence.
• Some errors are indicated using audible beeps and some are shown on the scale
display.
LCD Display Indicators
Displayed Text or Annunciator Description
- - - - No Bluetooth ® connection is established.
Motion/Stable Annunciator Weight is stable on the scale.
Lb Annunciator Displayed weight is in pounds.
Connection Annunciator Connection is established between J-Box/Indicator/Software.
-dL- Too many digits to display.
- U L - Weight is Under Load capacity.
- O L - Weight is Over Load capacity.
ErrC BlueLine Indicator or Software calibration sequence
failed.
Good Calibration sequence is successful.
COnn Indicator connected to BlueLine Software.
Lbat Battery charge below the operating range.
Conf Scale in Configuration Mode. Program changes are possible.
Battery Annunciator Battery charge getting low warning.
Counter-clockwise Dashes The Zero button is held down, turning the display off.
Audible Beep Errors/Signals
Alerts Displayed Message Description
Pulsing
(5-sec. beeps)
Ring Indicator searching for BlueLine
Software connection.
Pulsing
(10-sec. beeps)
CaLL Indicator attempting to pair with J-box.