Finish Thompson CQC-HD - Manual (Page 15)

Maintenance Schedule
EVERY USE:
CLEANUP ANY SPILLS – Antifreeze/coolants can be corrosive to the unit’s painted finish. Immediately
wipe, rinse and dry any spills thoroughly.
AS REQUIRED:
FLUSH THE DRAIN PUMP – Dirt and grit from waste coolant can cause premature wear on the drain
pump’s impeller. Periodically flush the pump by pumping 5 gallons of cool, clean water through the
red hose.
REPLACE PUMP IMPELLER – Replace impeller if loss of pump performance is noticed due to pump
being run dry, wear, or damage from foreign objects.
1. Disconnect power.
2. Remove cover plate from the pump head
(held in place with four phillip’s head screws).
3. Pull out old impeller.
4. Lubricate the new impeller with petroleum jelly.
5. Push the impeller onto the motor shaft at the same time twisting in a clockwise direction. This will
bend the blades in the direction for proper rotation.
6. Replace the pump’s cover using a new gasket. Tighten all screws evenly and snugly. Do not over
tighten the screws.
PRESSURE RELIEF VALVE – Replace the pressure relief valve if it appears to be stuck in an open or
closed position.
Warranty
Finish Thompson, Inc (manufacturer) warrants this product to be free of defects in materials and workmanship for a period
of 1 year from date of purchase by original purchaser. If a warranted defect, which is determined by manufacturer’s
inspection, occurs within this period, it will be repaired or replaced at the manufacturer’s option, provided (1) the product
is submitted with proof of purchase date and (2) transportation charges are prepaid to the manufacturer. Liability under this
warranty is expressly limited to repairing or replacing the product of parts thereof and is in lieu of any other warranties, either
expressed or implied. This warranty does apply only to normal wear of the product or components. This warranty does not
apply to products or parts broken due to, in whole or in part, accident, overload, abuse, chemical attack, tampering, or
alteration. The manufacturer accepts no responsibility for product damage or personal injuries sustained when the product
is modified in any way. If this warranty does not apply, the purchaser shall bear all cost for labor, material and transportation.
Manufacturer shall not be liable for incidental or consequential damages including, but not limited to process down time,
transportation costs, costs associated with replacement or substitution products, labor costs, product installation or
removal costs, or loss of profit. In any and all events, manufacturer’s liability shall not exceed the purchase price of the
product and/or accessories.
TECHNICAL SERVICE HOTLINE: 800-888-3743
13.