Finish Thompson LS-55IIE - Manual (Page 12)

11
JETVAC ATTACHMENT:
STOP/START - An illuminated push-button switch. Pull to ready the JetVac’s operation, push to terminate all
JetVac functions. A green light indicates that the JetVac is operating within the processing cycle.
IMPORTANT: The STOP/START push-button switch should remain ON (pulled) when wired for automatic
operation. In this mode, the Still will automatically turn on and off the JetVac depending on the status of the Still’s
operation. If vacuum operation is not required for a particular process, simply push STOP/START to the STOP
position.
VACUUM GAGE - A gage that indicates the level of vacuum, measured in inches of mercury being generated by
the JetVac measured in inches of mercury (0” to -30” Hg.). An increase in vacuum level decreases the boiling point
of the solvent being processed. The vacuum level can be adjusted turning the nuts on the vac adjust valve located
inside of the JetVac’s cabinet.