General Tools and Instruments 850 - Manual

Safety Instructions:
1. Always use eye protection when
using power tools. Wear safety
goggles that comply with ANSI 287.1.
2. WARNING: Always unplug drill from
power supply when changing bits and
attaching drill stops.
Helpful Tips:
1. This pocket hole jig will accept work
pieces up to 1-1/2" thick.
2. It is always best to practice making
pocket holes on scrap pieces of wood
to familiarize yourself with the tool.
3. The jig is equipped with mounting
holes for easy attachment to a fixed
work surface.
4. Pocket hole joinery requires drilling
pocket holes in only one of the two
pieces to be joined.
Before you get started:
The table below lists all the parts
included in the Pocket Hole Jig Kit.
Parts List:
ITEM # DESCRIPTION QUANTITY
1 Jig with screw clamp 1
2 Step Drill Bit, 3/8" 1
3 Stop Collar 1
4 Hex Wrench 1
5 #2 x 6" Square Drive Bit 1
6 #2 x 1-1/4" Fine
Wood Screws
24
7 #2 x 1-1/4" Course
Wood Screws
24
8 3/8" Wood Pocket Hole Plugs 24
PATENT
#6,254,320
Figure 4 / Figura 4 / Figure 4
Figure 5 / Figura 5 / Figure 5
Figure 1
Figura 1
Figure 1
Figure 2
Figura 2
Figure 2
Figure 3
Figura 3
Figure 3
Instructions:
1. Ensure that the stop collar on the step drill bit is positioned
at the correct height on the step drill to prevent drilling into
the jig base (see Figure 1). Use the included hex wrench
to loosen/tighten the stop collar.
2. Center the work piece to be drilled in the jig and clamp
tight using the thumb screw (see Figure 2).
3. Drill the pocket hole(s) until the stop collar hits the base.
For cleaner cut holes and easier drilling, do not drill the
entire depth with one stroke. Instead, use short strokes
until the drill has reached its final depth (see Figure 3).
When finished, unclamp the work piece and remove
from the jig.
CAUTION: Always make sure your drill and bit are up to
correct speed before contacting wood surfaces.
4. Clamp the two work pieces together in the desired final
configuration. Drive screws (1-1/4" course or fine screws
supplied), into the pocket holes to complete the joint
(see Figure 4). Glue may be used in the joint if desired.
GENERAL TOOLS & INSTRUMENTS
80 White Street, New York, NY 10013-3567
PHONE (212) 431-6100 FAX (212) 431-6499 TOLL FREE (800) 697-8665
e-mail: [email protected] www.generaltools.com
#850 Instructions Specifications subject to change without notice
©2011 GENERAL TOOLS & INSTRUMENTS NOTICE - WE ARE NOT RESPONSIBLE FOR TYPOGRAPHICAL ERRORS.
#850 10/14/11
ቢ
ባ
ቤ
ብ
ቦ
ቧ
ቨ
ቩ
If desired, insert 3/8" wood pocket hole plugs to cover pocket
hole (see Figure 5).
DELUXE
POCKET HOLE
JIG KIT
#850
INSTRUCTIONS
Please read these instructions carefully
and thoroughly before using this product.