Gentec-EO UP and XLP12 - Manual (Page 13)

Version 5.0
Ultra Series UP Instruction Manual Gentec Electro-Optics Inc. All rights reserved
9
a The calibrations at 2.1 to 2.5 µm and 10.6 µm are on special request only.
b See graph at the end of this section.
Specifications subject to change without notice.
UP10K-2S-H5-L Without PCB With PCB
Effective Aperture Diameter 10 mm
Spectral Range 0.19 – 20 µm
Calibrated spectral range a 0.248 – 2.5 µm and 10.6 µm
Power Noise Level
0.2 mW with anticipation
0.05 mW without anticipation
15µW with anticipation and moving
average mode (2 sec)
0.2 mW with anticipation
0.05 mW without anticipation
Typical Rise time (0-95%) 3.0 s (0.6 s with anticipation)
Typical sensitivity 2 mV/W 2 V/W
Calibration Uncertainty ± 2.5 %
Linearity with Power ± 2 %
Repeatability (Precision) ± 0.5 %
Power Resolution ± 0.5 %
Max. Average Power 2 S: 2 W
Max. Average Power (1 min)
(cooling : minimum 3 min)
2 S: 2 W
Max. Average Power Density b
1.064 µm, 2W CW
10.6 µm, 2W CW
36 kW/cm 2
11 kW/cm 2
Pulsed Laser Damage Thresholds
1.064 µm, 360 µs, 5 Hz
1.064 µm, 7 ns, 10 Hz
532 nm, 7 ns, 10 Hz
266 nm, 7 ns, 10 Hz
Max. Energy Density
5 J/cm 2
1.0 J/cm 2
0.6 J /cm 2
0.3 J /cm 2
Peak Power Density
14 kW/cm 2
143 MW/cm 2
86 MW/cm 2
43 MW/cm 2
Dimensions (mm) 50(H) x 50(W) x 20.6(D) 50(H) x 50(W) x 25.6(D)
Weight (head only) 2S: 0.13 kg 2S: 0.20 kg
Cooling Stand alone Stand alone
Recommended load Impedance 100 kΩ 10 MΩ
Output Impedance N. A. ≤ 50 Ω
Linearity vs beam dimension ± 0.7 %
PCB electrical supply N. A. + 12 V to + 16 V regulated
Max output signal N. A. 80 % of PCB electrical supply