Kasco Marine LR375 - Manual (Page 3)

3
LR275 Light Kit Assembly
Instructions
Instructions for mounting lights on:
Model 2400VFX, 3400VFX, 3400HVFX, 3400JF, &
3400HJF Aerating Fountains
STEP ONE:
Cut Nylon Zip Ties that hold the fi xture cords in a coil.
Insert the 1/4” x 1” bolt into the light bracket so the
fl ats of the hex head bolt are between the support ribs
of the bracket as shown in Figure 1. Align the light
bracket to the fl oat tab by placing the bolt through the
light mounting hole in the underside of the fl oat tab as
shown in Figure 2.
STEP TWO:
Install the 1/4” Flat Washer, 1/4” Lock Washer and
1/4” Nut against the underside of the fl oat tab as
shown in Figure 3. Tighten the nut until snug using
the 7/16” Wrench.
STEP THREE:
Adjust the angle of the light as desired and tighten the
two brass screws on the sides of the fi xture until snug.
Do not over tighten. It is best to have all two or three
fi xtures at the same angle.
General Instructions
INSPECT THE SHIPMENT
Immediately inspect your Kasco Submersible Light
Kit shipment for any visible damages. Also cross
reference the “Parts Included” section to check for part
shortages. Shortages should be reported immediately
to your Kasco Marine distributor or representative and
damages reported to your carrier and Kasco Marine.
PARTS INCLUDED
LR275
A. Light Kit with cord (1) •
B. 75-watt, 12-volt, MR-16 Halogen Bulbs, in- •
stalled in fi xtures (2)
C. 1/4” x 1” Stainless Steel Bolts (2)
•
D. 1/4” Stainless Steel Flat Washer (2) •
E. 1/4” Stainless Steel Lock Washer (2) •
F. 1/4” Stainless Steel Nut (2) •
G. Nylon Cable Tie •
H. Optional Colored Bulbs •
Note: Extra hardware may be included.
LR375
A. Light Kit with cord (1) •
B. 75-watt, 12-volt, MR-16 Halogen Bulbs, in- •
stalled in fi xtures (3)
C. 1/4” x 1” Stainless Steel Bolts (3)
•
D. 1/4” Stainless Steel Flat Washer (3) •
E. 1/4” Stainless Steel Lock Washer (3) •
F. 1/4” Stainless Steel Nut (3) •
G. Nylon Cable Tie •
H. Optional Colored Bulbs •
Note: Extra hardware may be included.
TOOLS & SUPPLIES NEEDED
A. 7/16” Wrench •
B. Flat Head Screw Driver •
C. Diagonal Pliers or Cutter for Nylon Zip Ties •