Kasco Marine LR375 - Manual (Page 4)

4
STEP TWO:
Cut Nylon Zip Ties that hold the fi xture cords in a
coil. Insert the 1/4” x 1” bolt into the light bracket so
the fl ats of the hex head bolt are between the support
ribs of the bracket as shown in Figure 1. Align the
light bracket to the lower fl oat bracket by placing the
bolt through the light mounting hole in the lower fl oat
bracket as shown in Figure 2.
STEP THREE:
Install the 1/4” Flat Washer, 1/4” Lock Washer and
1/4” Nut against the lower fl oat bracket as shown in
Figure 3. Tighten the nut until snug using the 7/16”
Wrench.
STEP FOUR:
Adjust the angle of the light as desired and tighten the
two brass screws on the sides of the fi xture until snug.
Do not over tighten. It is best to have all three fi xtures
at the same angle.
STEP FIVE:
Repeat steps 2 through 4 for the remaining two fi x-
tures. The completely assemble light fi xture is pic-
tured in Figure 4.
STEP FOUR:
Repeat steps 1 through 3 for the remaining fi xture.
The completely assemble light fi xture is pictured in
Figure 4. Note the orientation of the lights.
Figure 4
2 light install
Figure 5
3 light install
STEP FIVE:
Upon installation of the assembled unit, connect your
lighting package to your fi eld installed GFCI protected
outlet and timer. .
STEP SIX:
Using the nylon cable tie provided, tie the light kit
power cord to the fl oat opposite the fountain power
cord. This will keep the cord from being damaged by
the fountain and balance the unit properly.
Note:
Each light fi xture and cord entrance must be sub-
merged at least 1” in order for lights to operate prop-
erly.
LR375 Light Kit Assembly
Instructions
Instructions for mounting lights on:
Model 4400VFX, 4400HVFX, 8400VFX, 8400JF,
3.1JF & 5.1JF Aerating Fountains
NOTE: For 4400VFX & 4400HVFX follow Assem-
bly Instructions for LR275, but repeat with third light
fi xture. See Figure 5 in LR275 Assembly for correct
orientation. Also use LR275 instructions
If you purchased the LR375 for use on 2400 & 3400
models.
STEP ONE:
For ease of assembly, make sure the Aerating Fountain
is completely assembled. Place the assembly upright
and if needed, use blocks to support the fl oat.