Kasco Marine LLE1005 - Manual (Page 2)

2
CAUTION
NOTICE (NOTE)
These international safety symbols are used
throughout this manual to inform the owner of
important safety information and notices for safe and
effective use of the equipment.
THANKS!
We appreciate you choosing Kasco and for
your purchase.
Important Safety Instructions
Please read and follow these important safety
and handling instructions. Following these
instructions will help ensure your safety and
equipment performance.
CAUTION
Always disconnect power from light •
before service or relamping.
This Light is designed for submerged use
•
(see installation instructions). The internal
temperature protection will disable the light
if not submerged and greater than 20 watt
bulb is used.
Up to a 75W bulb can be used if the light
•
fi xture is submerged in water at least 25
mm to allow for proper cooling. Failure
to do so could damage the light. Always
use extreme caution around electrical
equipment and water situations.
Kasco Low Voltage Lighting must be
•
used with a 12V AC Safety Isolating
Transformer (SELV) with wattage capacity
greater than the sum of all light wattages on
the circuit. (Ex. Three 75W bulbs on the
same circuit would require a transformer of
at least 225W or greater.)
Caution should be used when dealing with •
any electrical equipment.
NEVER
• lift or drag the light by the power
cord.
General Owner’s Instructions
INSPECT THE SHIPMENT
Immediately inspect your shipment for any
visible damages or shortages. Report any
shortages to your Kasco Marine Distributor
and damages reported to your carrier and
Kasco Marine.
ASSEMBLY & INSTALLATION
Please see the proper assembly and installation
instructions enclosed in this manual.
USE AND OPERATION
Kasco Low Voltage Lighting must be used
with the proper size 12V AC Safety Isolating
Transformer (SELV). The wattage of this
transformer must be greater the sum wattage
of all the bulbs used on that circuit. The wires
on the Low Voltage Lighting must be wired
into the transformer per instructions included
with the transformer. The White and Black
wires on the Low Voltage Lighting are the
power wires. The Green wire is the GROUND
wire. Only connect the ground wire if
required by local or national codes.
Maintenance Recommendations
** Please keep the original box for
maintenance shipping. **
The following maintenance procedures can
be utilized to ensure many years of quality
performance from your Kasco Low Voltage
Lighting and reduce the need for more costly
repair work.