Kasco Marine LLE1005 - Manual (Page 4)

4
STEP ONE:
Mount the fi xtures in the desired locations. Up
to a 75W bulb can be used if the light fi xture is
submerged in water at least 25 mm to allow for
proper cooling. Failure to do so could damage the
light. If the included base is being used, rocks,
sand, etc. can be placed on the base to keep the
light in the desired location. A 1/2 inch (12.7mm)
PVC pipe can be added to the base to raise the
height of the light or the base can be removed and
the PVC pipe can be installed into the ground.
Standard Light
With Base Light with
base and PVC
extension Light with PVC
pipe for in ground
installation
STEP TWO:
Adjust the angle of the light fi xture as desired and
tighten the two brass screws on either side of the
fi xture to hold that angle.
STEP THREE:
Wire the cord from the Low Voltage Light into
the properly sized 12V AC Safety Isolating
Transformer. The transformer must have a
wattage capacity of at least the total sum wattage
of all the lights on the circuit. (Ex. Three 75W
bulbs would require a transformer of at least
225W or greater.) The Black and White wires on
the Low Voltage Lighting are the POWER wires.
They should be wired into the transformer per the
instructions included with the transformer. The
Green wire is the GROUNDING wire for the light
fi xture. The Green wire must be connected to a
ground per your local and/or national electrical
code.
Only connect the ground wire if required
by local or national codes. If in doubt, contact a
qualifi ed electrician.
STEP FOUR:
If the transformer has a timer included with it, set
the timer per the instructions included with the
transformer for the desired ON and OFF times.
STEP FIVE:
Plug the transformer into your RCD protected
240V power receptacle and enjoy your NEW
Kasco Low Voltage Lighting.
Troubleshooting Tips & Warranty
For more tips and information contact your Kasco
distributor or go to
www.kascomarine.com (Under the technical tab)